Grasshopper

algorithmic modeling for Rhino

blow up

Hi at all,

I want to try something like that (large)

What I got so far

How can I get more "pressure" in that, so that the "bubbles" push each other like in the picture above.

Hope you have an idea :)

Views: 1104

Attachments:

Replies to This Discussion

Permalink Reply by Dan Greenberg on June 13, 2013 at 8:46am

Not sure if this helps, but with Kangaroo, you can play with the stiffness of springs. Low values will be more elastic, higher values will be more rigid. Do a wind simulation and try turning off gravity off or reverse it. Adjust the wind so that it comes from below the panel. This should get you closer to the feel you are looking for. Look at collisions too. Although you may need more than one panel to use collisions in the manner you are describing.

Permalink Reply by Michael Herbig on July 11, 2013 at 9:39am

I got closer to what I am looking for...my next problem is, the pillows doesn't affect each other as you can see at the picture. any idea?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service