Bend Sheet anchor Points

Hi All,

I am a novice with Kangaroo so please excuse my knowledge level, I have been testing a number of the examples posted by Daniel specifically one relating to plane optimisation and bending sheets.

However I am having a strange Issue with the example of sheet bending posted on the thread below. When I start the simulation only one of the anchor points is working therefore the sheet sucks into the one point that is working.

I am using the latest building of kangaroo and Grasshopper, I have tried a number of different changes but am yet to solve this issue, if anyone could point me in the right direction that would be really helpful.

Cheers

Iain

http://www.grasshopper3d.com/group/kangaroo/forum/topics/new-versio...

Attachments:

bendsheet.ghx, 281 KB
bendsheet.3dm, 45 KB

Replies to This Discussion

Permalink Reply by Chris Ingram on October 22, 2011 at 7:00am

I also cannot get this definition to work.

I imagine that it is something very simple but for some reason when i set simulation reset to false - the mesh disappears. Can anyone get this to work or advise what the problem might be?

many thanks

RSS