algorithmic modeling for Rhino
SAP2000 Load combinations
I wanted to check the deflection at mid point of truss for service load combo i.e.
Service combination: 1Dead Load Case+ 1Live Load Case
I have tried the sequence as shown in the attached Image 1.
Rhino status bar shows error ''Material Count: 2, SectionProperty Count: 6, Node Count: 21, Element Count: 41
Load Pattern Count: 1 Loads: 7 Load Case Count: 2
+++ Analysis Successful!
Unable to extract results for joint ggGHn21
Unable to extract results for joint ggGHn21''
The grasshopper definition file is attached as well.
It seems that SAP2000 is not defining the load pattern for dead loading.
On the other hand, when I analyze for Live load case only, the results are fine. Please refer attached Image 2.
I would be grateful if anyone can guide where am I making the mistake.
Views: 948
- Attachments:
-
-
Image 1.png, 194 KB -
Image 2.png, 107 KB
-
Space truss optimization v1.15 (trial).gh, 60 KB
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
© 2024 Created by Scott Davidson.
Powered by
