Grasshopper

algorithmic modeling for Rhino

need support on “ggGeoDome”

Hello，I have a question on module "ggGeoDome", the vertex of the polyline curves it generates do not coincide, but if I invert the boolean of "Lines", the vertex are coincide.
So is there a way to make the vertex of the polyline curves coincide?
Thanks for your reply.

Views: 173

Replies to This Discussion

Permalink Reply by Jon Mirtschin on March 28, 2021 at 11:13pm

I'm not sure if it's just a lack of precision in the algorithm or not, but the component forces the curves to be planar.  Hence the lack of vertex coincidence.

Do you need the polylines to be planar?  I'd need to go revisit the algorithm.  There were other implementations since I developed this that might be more accurate.

Permalink Reply by Emma Kayro on October 22, 2021 at 9:32am

I will try, maybe! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service