Grasshopper

algorithmic modeling for Rhino

Rabbit with Lattice

Hello,

Does anyone have any hints how to approach the 'Rabbit with Lattice' that was apparently made using Crystallon?

I thought maybe fill a bounding sphere with voxels and use the Rabbit mesh to trim.

But I don't seem to find that particular unit cell in either lattice or shell form.

And on a related note I've had difficulties to Thicken a simple Cubic Center shell using the techniques from the Example file.

Would be keen to figure this out so I can apply the technique to others parts.

Thanks,

Dana Churchcrystallon_doc_render.5_result.jpg

Views: 509

Replies to This Discussion

Permalink Reply by dana church on March 2, 2020 at 10:30am

Upon reflection, perhaps it is a Custom unit cell that is Morphed to the Rabbit Skin, then Thickened with Pipes.

Permalink Reply by Aaron Porterfield on March 11, 2020 at 1:34pm

Hi Dana,

What you see there are the "voxels" made by using the "offset mesh" components. If you use a triangulated mesh, it will create a quad mesh from each triangle like you see. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service