(x,y,z) points to (u,v) points

Replies to This Discussion

Permalink Reply by David Rutten on April 28, 2017 at 7:44am

Use the [Surface Closest Point] component. It will output UV points.

Permalink Reply by Ibrahim on April 28, 2017 at 7:47am

Thanks David, whatever was the surface I will get the right uv points ?

Permalink Reply by David Rutten on April 28, 2017 at 8:16am

Should be correct, unless there's a bug in the surface closest point algorithm, but that would be very unlikely as that code is used all over Rhino.

It'll of course output an xyz point, but the z value will be zero and the x and y values will represent u and v respectively.