Wrong Fillet

HI,

I have a problem with fillet (with crvs).

If I use the regular fillet, in case my segment is too small, it applies a smaller fillet, instead to recessed and find the correct point for curvature (see red crvs on the image below).

If I use Fillet with parameter, the fillet is quite correct, but it shows me four different crvs, one for each point of discontinuity of the polygon.

Of course I'm doing something wrong. Could you please explain me what to do?

Thanks.

Attachments:

Fillet.gh, 28 KB

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on November 3, 2017 at 12:54am

Hi.

If you don't mind to reduce your polyline's insignificant vertices by using "RedPline", then, the normal fillet would be better to get what you are after.

Otherwise, you can use "Region Intersection" to extract one closed curve with your 4~5 individual curves produced by "Fillet with parameters".

Attachments:

Fillet_re.gh, 30 KB

Permalink Reply by Dario on November 3, 2017 at 3:52am

Thanks for your reply.

Yes, RedPline helps, but, as you can see from your image, the last one on the right has a smaller radius.

I solved as per your suggestion of region intersection, but I'd like to know if there is a way to avoid the duplicates I found (it's a little bit slow). Please see attachment.

Attachments:

Fillet_001.gh, 33 KB

Permalink Reply by Dario on November 8, 2017 at 5:00am

just for my personal curiosity...

is it correct how I did the connection for RegionIntersection?
In this way I have each repetition for each polyline of the intersection (same results). That's why at the end I have used list item to choose just one of these crvs.

Thanks

RSS