Wooden slats on a surface

Replies to This Discussion

Permalink Reply by Laurent DELRIEU on January 22, 2014 at 3:16pm

Hello Dani

here is an example, with panel just in one direction, I did extract point of isocurve, I made a translation in U direction (forward, Backward) and normal direction so I had 4 curves, I made after that a Sweept 2 rail with a section line. I made a plane with 4 sections line at the beginning. You have to make the end side.

I normalize height and width.

Hope it helps

Attachments:

• woodenslats LD.gh, 75 KB

Permalink Reply by Dani on January 23, 2014 at 2:00am

Thank you very much Laurent for your help, really.

I didnt figure it out how to make the translation but what you have made is exactly what i was looking for... Anyway, could you please attach an image of the definition because you have the newest version of GH and rhino and im still running the old one :(

I m allways learning new GH ways to solve my drawing problems, hope someday could help somebody like you just did. 

Thanks!!

Permalink Reply by Laurent DELRIEU on January 23, 2014 at 11:18am

Here is the image. I also pu GHX, pherphas it could be used !

Attachments:

• woodensla.png, 1 MB
• woodenslats LD.ghx, 514 KB

Permalink Reply by Dani on January 23, 2014 at 11:29am

O_o

Woww... i thought this definition was going to be quite easy and i just was missing something but i was completly wrong... THANK YOU VERY MUCH!!! 

It will take me a bit of time to analyze and understand it but it will be very helpful for learning new comands =)

Thank you again and i hope to ul soon the result

Permalink Reply by Oliver Hidalgo on April 2, 2015 at 8:13pm

Thanks for sharing!