What does it mean when I have this error message ?

I'm trying to run some Energyplus simulations, I get two error messages:

1. No .eio file was found adjacent to the .csv _resultFileAddress.Results cannot be read back into grasshopper without this file.

2-2. No surface information was found in the imported .eio file adjacent to the .csv _resultFileAddress.Data cannot be normalized by surface area and the data tree outputs for surface data will not be grafted by zone.

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on February 28, 2015 at 9:21am

It's usually a result of failure of energy simulation in the first point. Are you sure the simulation is running fine?

Permalink Reply by Ernesto Cesario on May 5, 2016 at 4:36am

Hi Mostapha,

I get the same error..I've seen all the discussion replies; I updated the file components as Rania did too; I wrote a new the algorithm so to avoid Rania problems(as suggested from Chris) but still I have the same error: "1. No surface information was found in the imported .eio file adjacent to the .csv _resultFileAddress.Data cannot be normalized by surface area and the data tree outputs for surface data will not be grafted by zone". It's a long time that I'm trying to figure out what's the problem..could you please have a look to the file?THANK YOU SO MUCH

Attachments:

error_noshade.gh, 555 KB

Permalink Reply by Abraham Yezioro on May 5, 2016 at 5:43am

Ernesto,

There were supposed to be problems with the file you attached?

Just a couple of issues that i fixed it works fine for me. See attached.

-A.

Attachments:

error_noshade_AY.gh, 557 KB

Permalink Reply by Ernesto Cesario on May 5, 2016 at 8:20am

Abraham,

thank you very much, now it works!

Ern

Permalink Reply by Ninja on February 28, 2015 at 10:01am

Mustapha, thanks for replying to my question. The simulation fails, I'm not sure why, as you can see from he picture I think I have the right setup.

Permalink Reply by Ninja on February 28, 2015 at 2:40pm

After I updated my HB using the update Honeybee components the simulation fails, it used to run fine right before the update. I noticed some empty outputs coming out the HB flying component, is there something wrong with my installation? I really need to figure out what's happening with this as I have a deadline to finish this work for a research paper I'm working on.

Thanks in advance

Permalink Reply by Mostapha Sadeghipour Roudsari on February 28, 2015 at 2:43pm

That shouldn't make any issues. Can you upload your file so we can take a look? I can check it later today. -Mostapha

Permalink Reply by Ninja on February 28, 2015 at 2:58pm

Here are the files, I really appreciate it.

Attachments:

Final.3dm, 2.4 MB

Permalink Reply by Ninja on February 28, 2015 at 3:03pm

and here is the GH file

Attachments:

Final_r.gh, 1.5 MB

Permalink Reply by Mostapha Sadeghipour Roudsari on February 28, 2015 at 2:46pm

Also it might be helpful if you read readMe! output of runEnergySimulation component. You can find the error in your simulation there.

Permalink Reply by Ninja on February 28, 2015 at 2:59pm

I'll take a look right now

Permalink Reply by Ninja on February 28, 2015 at 3:05pm

Here is the error output, it says there is a missing input. However, the picture below shows that I've connected all required data, unless I'm missing something