weld mesh

Replies to This Discussion

Permalink Reply by RENE on September 18, 2017 at 2:52pm

hey you could try this example then just 'DeBrep' your result and mesh it, then WbJoin and weld

http://formularch.blogspot.com/2012/04/gh-image-gills.html

Permalink Reply by Michael Pryor on September 18, 2017 at 7:02pm

I would say better to use this one - http://formularch.blogspot.com/2012/11/gh-surface-ribbons.html

Permalink Reply by AHMED MAHMOUD on September 19, 2017 at 12:19am

thanks michael

Permalink Reply by AHMED MAHMOUD on September 19, 2017 at 12:19am

i try you idea but the points are not coincidence

Attachments:

• kkk.png, 386 KB

Permalink Reply by AHMED MAHMOUD on September 19, 2017 at 12:21am

the points are not coincidence

Attachments:

• Untitled.pngdd.png, 172 KB

Permalink Reply by Hyungsoo Kim on September 19, 2017 at 1:23am

Hi. AHMED MAHMOUD.

Your problem has nothing to do with the "Gill Facade" shown in the reference image.
What you want is just a matter of tolerance in mesh welding.
You can easily fix it by using the component already in your previous definition.
It would be good not to make it difficult to solve your problem by uploading image that are not related to your specific problem.

Attachments:

• kishoom22_re.gh, 26 KB

Permalink Reply by AHMED MAHMOUD on September 19, 2017 at 5:34am

thanks  Hyungsoo Kim ..but when i try to modify any slice 

Permalink Reply by Hyungsoo Kim on September 19, 2017 at 7:09am

So, you don't know what to adjust? See parmeters grouped red.

Attachments:

• kishoom22_reV2.gh, 23 KB