Weird baking bug

HI guys, i ran into a problem i don't even know, it may be unrelated to grasshopper, i don't think so though. I was wondering if anyone has gone through something like this. I have an extruded brep that has holes in it, the holes are made into a surface before extruding it, it works fine until I bake it, then a very strange thing happens.

As you can see in the image, form one side of the brep you can see right through the holes, however when i rotate the view it seems caped. i tried many things none are working,

also, if i explode the brep into surfaces in rhino it view is blocked from both sides , but i can take away the surface that is blocking the view...

I'd appreciate any help or thoughts on that

Diego

Replies to This Discussion

Permalink Reply by David Rutten on September 10, 2009 at 6:25pm

Looks like a meshing bug to me. Grasshopper uses extremely low mesh settings because it needs to generate a lot of them in a short amount of time, but once you bake something the BRep is meshed according to document settings.

Can I see the geometry?

Permalink Reply by diego on September 10, 2009 at 6:38pm

Do you want me to send you the files or just paste more images of the whole thing, sorry didn't quite understand what you meant ...

Permalink Reply by Vicente Soler on September 10, 2009 at 9:15pm

Here's another thread about the same problem:
http://www.grasshopper3d.com/forum/topics/inset-command-in-grasshopper

Just increase the mesh quality of the baked object and the opening will appear again.

Permalink Reply by diego on September 11, 2009 at 6:10pm

Vicente and david: hi, that's awesome thanks a lot, i can't believe i couldn't remember that thread, I had read it also but i didn't quite understand what was going on that time(neither this) hahah, thanks a lot again that was very helpful.

Diego

RSS