weaverbird only shows up in command line not in grasshopper?

Replies to This Discussion

Permalink Reply by Giulio Piacentino on July 6, 2011 at 2:04am

I think this might happen if the account that installed Wb is not the final user and/or if Rhino was open while installing.

There's an easy fix:

• close Rhino
• find the folder of the Weaverbird installation (you can also look it up with the _PlugInManager command, scroll down to Weaverbird, Properties. The folder is under Technical Information)
• execute GhRegistrator.exe from there with no impersonations (double click)

Hope it helps,

- Giulio

Permalink Reply by Archieboy on July 6, 2011 at 3:27am

Hi Giulio, I logged off and asked the administrator to re-install it for me using the most updated version on your website and it works. I haven't tried your options but thanks!

Permalink Reply by Andrew Wallace on July 18, 2011 at 9:41pm

Hey Guilio - this worked for me. Sweet.

Permalink Reply by Ben on July 19, 2011 at 9:11am

Worked for me too! thanks!

Permalink Reply by Adam Fenton on August 27, 2011 at 9:08pm

Thank you Giulio!!!!