weave command

Replies to This Discussion

Permalink Reply by David Stasiuk on November 5, 2013 at 9:16am

Use the ZUI...it's a part of any component that has the ability to add or remove inputs dynamically...so just zoom in close on the canvas and you'll see little +/- buttons emerge where you can change your inputs or outputs depending on the component.

Permalink Reply by maxk on November 5, 2013 at 9:46am

thanks a lot!
total beginner...sorry ;)

Permalink Reply by David Stasiuk on November 6, 2013 at 12:24am

:)