Grasshopper

algorithmic modeling for Rhino

waffle structure production

Hello Dear Grasshopper masters :)

I created a waffle surface at grasshopper, and now want to prepare to production. I want to orient my modules, lay down the xy plane. There is a problem that i could not understand up to know. I guess the mistake about lists. There is much more module that i need to produce the system. And some of them double. I am attaching the files. Could you please explain where is the problem? 

Thanks in advence! 

Views: 1026

Attachments:

Replies to This Discussion

Permalink Reply by Danny Boyes on December 3, 2013 at 4:20am

One of the many reasons why Icon View is better than Text View :)

The Results of the Curve Length component was producing 6 numbers of 58 so you were getting 6*58 = 348 Section Curves to lay out.

Permalink Reply by trawellness on December 3, 2013 at 4:53am

Cool! Never text view anymore :)

Thank you so much Danny.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service