Voronoi wall

Replies to This Discussion

Permalink Reply by Hannes Löschke on February 19, 2013 at 1:16am

How would your pitch, amplitude and time relate to the surface you posted? By vertices do you mean the input to a Voronoi3D, or the corner vertices of your planes?

If it's the corners, you cannot expect more than 3 vertices to form a flat panel. Best you can do is to use Delaunay to mesh your vertices.

Permalink Reply by benjamin paskus on February 19, 2013 at 9:54am

Amplitude determines z values (distance from wall).  Time determines x values and Pitch determines y values. By vertices I mean the input to the Voronoi3D component. 

The best I can do is Pop3D --> Voronoi3D --> Bake --> and Delete surfaces in Rhino.  Any way to get a surface like the picture above without subtracting from Voronoi3D?

Permalink Reply by Hannes Löschke on February 19, 2013 at 2:19pm

Well you can cull out surfaces by checking against given geometry such as outer boundaries. this should be kind of the reverse of this problem here.

Permalink Reply by Michael Pryor on February 19, 2013 at 3:12pm

schange cull duplicates from leave one to cull all and connect to list item instead of cull item. http://www.grasshopper3d.com/forum/topics/how-to-find-complanar-fac...

Permalink Reply by benjamin paskus on February 23, 2013 at 5:33pm

wonderful advice everyone, I'm very happy with the form.

 

I'm beginning to unroll the surfaces for printing and noticed some of the cells have too many surfaces for my liking. 

 

Is there anyway to reduce/controll the amount of surfaces Voronoi3d uses? 

Or maybe set a minimum surface size?

Attachments:

• Voronoi_3d.gh, 2 KB

Permalink Reply by Archy Bloom on February 27, 2013 at 5:54am

I found a way to create this type voronio wall.

wish helpful to you .

Attachments:

• voronio form wall.gh, 12 KB

Permalink Reply by benjamin paskus on February 27, 2013 at 11:19am

amazing.