Grasshopper

algorithmic modeling for Rhino

voronoi srf loft problem

Salut,
another day another problem! :-)

Any idea how to solve the following problem? I did it as far as I could, but i don't know how to bring a surface to the voronoi system on the target surface. Guess it depends on the trimmed curves, they aren't closed so I can't loft them, ...

I appreciate any help!

 

Thx,
Sebastian

Views: 1119

Attachments:

Replies to This Discussion

Permalink Reply by Dedackelzucht on August 8, 2011 at 2:07am

Hey,

smash your RhinoSrf

put a rectangel (does not have to be a 90deg corners(i think)) in the aspect ratio into it

map the edges of the rectangel to original Srf

generate a edgeSrf by the new outlines

take this Srf to map the voronoi

 

maybe this works :-)

 

Best regards

 

DeDackel

Permalink Reply by Pieter Segeren on August 8, 2011 at 3:51am
Hi Sebastian, this might be a way (NB I didn't check if the i-1 expression in the List Item component will work for the other surfaces as well)
Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service