Voronoi Offset

Replies to This Discussion

Permalink Reply by David Rutten on May 18, 2014 at 2:13pm

Offset is purely a 2D operation. If your curve is not planar, Rhino will break it apart into pieces which are planar and then offset each one individually. There's an Offset On Surface component as well as a Loose Offset component that may do what you need.

--

David Rutten

david@mcneel.com

Permalink Reply by Nalmen on May 18, 2014 at 2:38pm

Thank you,

The Loose offset seems to work, but now i cannot cap the holes.
Is there a problem with the new intersections? 

The component says the Algorithm Failed to return as a result. 

Any Ideas? 

Permalink Reply by ng5 Alex on May 18, 2014 at 2:48pm

in cap holes component description you can see ''cap all planar holes in a brep''.

are these holes planar? cant tell from screenshot for sure, but they don't seem to.

Permalink Reply by Nalmen on May 18, 2014 at 3:03pm

They are not, the cap hole component does not work..

Here is the definition 

Attachments:

• RhinoSist.3dm, 496 KB
• Rhino.gh, 8 KB

Permalink Reply by Erick Vásquez on May 18, 2014 at 3:06pm

as ng5 said, use patch for these case.