voronoi cut

how to make the network Voronoi lines are cut with the offset curve?

Attachments:

vor_f.3dm, 60 KB
voronoi-curva.gh, 4 KB

Replies to This Discussion

Permalink Reply by lucas cañada on December 9, 2011 at 2:33pm

Hi Fernando, could be like this?

Attachments:

voronoicurva_1.gh, 6 KB

Permalink Reply by fernando molas garcia on December 9, 2011 at 2:55pm

thanks lucas!

the truth is very close to being what I need!

attached a picture of what you need ...

regards

Permalink Reply by lucas cañada on December 9, 2011 at 4:04pm

Just a manual aproach hope help you ;)

Still didnt fixed fillet problem

Attachments:

voronoicurva_3.gh, 7 KB

Permalink Reply by fernando molas garcia on December 9, 2011 at 4:21pm

thanks lucas!

particular outcome is achieved but the disadvantage of having to adjust the definition for different cases. but I think that there is the road ...

regards

Permalink Reply by fernando molas garcia on December 9, 2011 at 4:30pm

Lucas

I will try to sort the list based on the length of the curves and then "filter" with this approach so as to leave only the curves "long" which are those that close the "islands".

mario you think?

Permalink Reply by lucas cañada on December 9, 2011 at 4:43pm

Could be one way, let us see when succes...see you.

Permalink Reply by MARIO VERGARA on December 9, 2011 at 4:07pm

please see definition attached....

best

Attachments:

voronoicurva2.gh, 6 KB

Permalink Reply by lucas cañada on December 9, 2011 at 4:23pm

nice one

Permalink Reply by fernando molas garcia on December 9, 2011 at 4:24pm

Mario always on the ball!

Very clever your approach, but the "bars" are of different thicknesses!

thanks

Permalink Reply by Jon Mirtschin on December 9, 2011 at 11:20pm

Attached is the geometry gym solution if you're interested. Embedded into the code is routines to (hopefully) fillet around short edge curves etc that can be present in voronoi diagrams. The grasshopper definition can become complex (like the code) if you have to handle them.

Attachments: