Grasshopper

algorithmic modeling for Rhino

Voronoi Boundary

Hi my name is Alex,

I'm trying to change the boundary for the voronoi component so that it does not use the default rectangle.  I've tried using a couple of iterations, by exploding the component and rebuilding it for the desired geometry, but it always goes back to a rectangle.  I want my borders of the srfs to be boundary instead of the rectangle.

Please take a look at the attached rhino and grasshopper file.  Any help would be greatly appreciated.

Thanks,

Alex

Views: 1308

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 2, 2015 at 9:10pm

Hi.

You can add the red part to your def.

Attachments:
Permalink Reply by Alex Behnke on August 2, 2015 at 10:08pm
Thank you very much for your help, that looks much more like what I'm going for. Appreciate it.
Permalink Reply by Pieter Segeren on August 3, 2015 at 2:39am

Hi Alex - Hyungsoo, I would use an other component from the intersection tab: RegionIntersection (instead of TrimWithRegion):

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service