Grasshopper

algorithmic modeling for Rhino

voronoi and voronoi group

HI, I have a question about voronoi and voronoi group on GH.

When I set multiple points to voronoi, it works well.

but when I set the same multiple points to first generation to voronoi group, it has lines intersecting itself.

I wonder if there is way to make sure the vorgroup would generate voronoi as clean as voronoi.

Views: 2259

Attachments:

Replies to This Discussion

Permalink Reply by tiantian sun on December 8, 2011 at 10:00am

No wonder no one respond to this question because it is too easy.

Just figure out that the reason might be there are duplicated points. And luckily there are remove points and remove lines definition in GH now.

Remove duplicated points first, than the voronoi group G1 would be as clean as voronoi.

Permalink Reply by David Rutten on December 8, 2011 at 10:17am

Glad you figured it out, it's hard to see that from an image :)

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Michael Pryor on December 8, 2011 at 12:00pm

Probably a dumb question, but whats the difference in components?

Permalink Reply by Esraa Esmail Abdelaziz on June 3, 2013 at 11:47am

please I want to know how to make 3D vornoi in Free forms plzzz any help ??

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service