Visualize Annual Radiation Simulation with Honeybee

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on June 7, 2017 at 9:06am

Check this example on Hydra.

Permalink Reply by Federico on June 7, 2017 at 8:24pm

Thanks Mustapha for the quick reply.

I have checked both this example you gave here, and also the workshop in youtube to make sure, a part of searching here in the posts, but I am still not able to visualize the annual radiation values for the surface I want to calculate.

The Output I can have with the "readAnnualResultsI" component allows me to have the DA, UDI, etc.. that depends on occupancy, illuminance levels, etc...

I have tried with other component but without any luck.

So I am stuck where I was before.

I enclose part of the file I am working on.

As you can see what I can visualize are DLA, UDLI, CDA and sDA only, I cannot find the option to see the annual radiation.

If you can have a look it would be very helpful!

Thanks again for the support,

Federico

Attachments:

• Example_Radiation.gh, 546 KB

Permalink Reply by Abraham Yezioro on June 7, 2017 at 11:02pm

Federico,

See attached for working version (white group in file). You were wrong in the analysisRecipe and the chosen sky.

Look also for Image Based simulations. See above red panel.

-A.

Attachments:

• Example_Radiation_AY.gh, 591 KB

Permalink Reply by Federico on June 12, 2017 at 12:10am

Hi Abraham!

I had completely forgotten about the cumulative sky.

Thanks for the help!