Visualization Problem?

Hi,

i'm designing a standing and i'm having a problem with the visualization, i think so. i'm having the same problem on rhino 4 and 5. already tested on another computer and the same problem occurs.

any ideas?

Attachments:

Untitled.3dm, 478 KB

Replies to This Discussion

Permalink Reply by Victor Sardenberg on May 28, 2012 at 2:06pm

Permalink Reply by David Rutten on May 28, 2012 at 2:34pm

Hi Victor,

it looks like your geometry is either very very small, very very large or very very far away from the origin. Meshes are stored as single-precision data in Rhino whereas nurbs data such as wireframe curves is stored as double-precision. This means that meshes don't behave when they contain very small or very large numbers.

The only solution it to make sure you pick common-sense units (i.e. don't work in millimeters when designing a city, don't work in kilometers when designing a hand-held) and keep your geometry near the world origin point.

Further information: http://wiki.mcneel.com/rhino/farfromorigin

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Victor Sardenberg on May 28, 2012 at 3:27pm

Nice David,

Thank you!

RSS