VB joining two curves

Replies to This Discussion

Permalink Reply by Thibault Schwartz on February 26, 2012 at 5:54am

Rhino.Geometry.Curve.JoinCurves(AllYourCurvesAsArray, Tolerance, TellIfYouWantToPreserveDirection)

Permalink Reply by Sven Nevlida on February 26, 2012 at 10:49am

thanks a lot ;)

Permalink Reply by Sven Nevlida on February 26, 2012 at 11:07am

I have just realized, that is not that clear yet - where is the result stored? 

Permalink Reply by Thibault Schwartz on February 26, 2012 at 11:11am

You just have to set the result to an array or an existing list.

Dim MyJoinedCurves as New List (of Rhino.geometry.curve)

MyJoinedCurves = Rhino.Geometry.Curve.JoinCurves(AllYourCurvesAsArray, Tolerance, TellIfYouWantToPreserveDirection).tolist

Permalink Reply by Sven Nevlida on February 26, 2012 at 11:15am

ok, I've been trying to set the result to a curve variable... again thanks

Permalink Reply by Sven Nevlida on February 26, 2012 at 12:27pm

still not working :(

Permalink Reply by Thibault Schwartz on February 26, 2012 at 12:34pm

You are adding a list to a list, so you have to use addrange, and not add line 135.

Permalink Reply by Sven Nevlida on February 26, 2012 at 12:48pm

but the problem seems to be on the line 134 - it says that "tolist" is not a member of System.Array.

Permalink Reply by Thibault Schwartz on February 26, 2012 at 12:53pm

Ah, so use

MyJoinedCurves.addrange(Rhino.Geometry.Curve.JoinCurves(AllYourCurvesAsArray, Tolerance, TellIfYouWantToPreserveDirection))

Permalink Reply by Sven Nevlida on February 26, 2012 at 5:27pm

so it worked ;) thx