Grasshopper

algorithmic modeling for Rhino

Varying Thickness of Section - Rabbit Plug In - Tree Structure

Hi,

I have created a tree structure using the Rabbit add-in. And from the lines produced extruded rectangle sections.

I am wondering how I can vary the thickness of the sections: so the base of the tree would have a wider section and the width would decrease the higher the branches.

Attached is the gh. file. The Rabbit plug in is needed.

Thanks for your help and time.

Nate

Views: 383

Attachments:

Replies to This Discussion

Permalink Reply by Laurent DELRIEU on November 25, 2016 at 11:48am

I have no rabbit, but if you have some connected lines you could use some scripts found in this discussion

http://www.grasshopper3d.com/forum/topics/shortest-walk-tapered-bra...

Permalink Reply by Nate Crosby on November 25, 2016 at 12:31pm
Hi Laurent,
Thanks for the link I'll have a look and try to get somewhere.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service