Varying radius with Voronoi component

Replies to This Discussion

Permalink Reply by Milan Domkář on January 23, 2011 at 5:11am

The problem is that voronoi works only with set of point. If you want to assign diffrent radii to each point it will not work as a set of points (you have to graft it) and voronoi works only with set of points. 

I think that basic idea of making voronoi is to make perpendicular line in the middle of two points. In your case perpendicular line is not situated in the middle because of different radii. It is complicated :)

Permalink Reply by WoodDuck on January 23, 2011 at 12:48pm

Thanks for the response - I'll carry on with a single set of points.

Cheers.

Scott

Permalink Reply by Milan Domkář on February 1, 2011 at 1:31am

hmm if I'm not to late try metaball instead of voronoi - this is what you are looking for..

Permalink Reply by WoodDuck on February 1, 2011 at 10:03am

Thanks - that helps.

Permalink Reply by Andrew Heumann on February 1, 2011 at 10:53am

also see this thread for ways of accomplishing weighted voronoi: http://www.grasshopper3d.com/forum/topics/looking-for-weighted-voronoi

Permalink Reply by Dedackelzucht on February 1, 2011 at 11:04am

My solution is not that smart, but somehow i like it:-)

Attachments:

• voronoi_J.3dm, 33 KB
• voronoi_J.ghx, 321 KB