Grasshopper

algorithmic modeling for Rhino

using true false values

Inline image 1
The panel is showing points that are less than a certain distance from another point.
I am trying to get the three points that came up "true" to make the verticies of a surface. This is where I am at.  What am I missing?

Thank You

Views: 2629

Replies to This Discussion

Permalink Reply by Chris Tietjen on November 19, 2012 at 8:15pm

This is a contrived example since your image didn't post but it may give you an idea of how to proceed.  I'm sorting the indices of the point list along with the distances from the particular point to get the point set for the three vertices.  Then it's a closed polyline to an edge surface.

Permalink Reply by book learnin on November 20, 2012 at 11:50pm

Thank you so much next time you are in Chicago I owe you dinner!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service