Grasshopper

algorithmic modeling for Rhino

unwanted repeated extrusion in same location

Hey Guys

One small problem with my simple script that i haven't been able to work out for the past hour. 

Basically im using a point attractor to set the height on extrudes squares.

The extrusion works fine however in one of the corners of the field it repeats the cube 10,000 times as shown.

 

Is there somewhere in the script in particular i need to flatten or otherwise?

Any help would be greatly appreciated!

Views: 336

Attachments:

Replies to This Discussion

Permalink Reply by Mohamed Naeim on October 25, 2016 at 9:27pm

Attachments:
Permalink Reply by Davis Watts on October 25, 2016 at 10:53pm

Hey Mohamed, thanks for the response.

However the new script seems to only extrude the same way no matter where the point is. meaning say for example you are looking at it from one way the right side will always be lowest and the right side always tallest, no matter where the point is.

I require it to be the same as in my script where the squares closest to the point attractor are extruded the most. 

All was working well in mine besides the doubling up of geometry.

Would you know what to do there?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service