Uneven Subdivision

Replies to This Discussion

Permalink Reply by Matthew McFetridge on October 3, 2012 at 11:15pm

Hi mate,

I literally had the exact same issue a few weeks ago and it was to do with the path mapper not set correctly.

Here is the file I have updated for GH 0.90014

Attachments:

• Uneven Subdivision_Co-de-iT_GH090014.gh, 10 KB

Permalink Reply by RWNB on October 4, 2012 at 2:34am

thanks matthew!

Permalink Reply by Enas AlKhudairy on December 2, 2012 at 2:29pm

Hi,

I was trying to create something similar to this but where the panels are random in both directions, but wasn't able to do it. The other solution I found was this: http://www.grasshopper3d.com/forum/topics/uneven-surface-subdivisio... but that doesn't allow me to change the rectangle proportions (it keeps the original proportions). I tried to find a different way to get the result but the problem is the rectangles intersect. Here's my gh attempt and the result I'm trying to achieve.

Thanks in advance for any help.

Attachments:

• result.jpg, 42 KB
• gh-help.jpg, 692 KB

Permalink Reply by Michael Pryor on October 3, 2012 at 11:23pm

http://formularch.blogspot.com/2012/04/gh-gradient-subdivision.html...

Also use random lists with mass additions partial results.

Permalink Reply by RWNB on October 4, 2012 at 2:34am

thanks matthew!

Permalink Reply by RWNB on October 4, 2012 at 3:21am

Maybe a question more!

How to Cull subsurfaces in column direction?

how can i organize the respective areas (U SubDivisions) ,
to select specific areas of every second column.
i want to turn off some of them, to create a pattern.

1. the U-subdivision should be odd.
2. the selection of the surfaces should only place in every second column.
3. if the subdivision is changed, the principle should be maintained.

Attachments:

• cull.3dm, 44 KB
• UnevenSubdivision_CodeiT_GH090014.gh, 11 KB

Permalink Reply by RWNB on October 4, 2012 at 5:05am

i created a collgae of systemiq and danny boyes definitions.

http://www.grasshopper3d.com/forum/topics/irregular-cull-pattern
http://www.grasshopper3d.com/forum/topics/culling

but still the pattern shows regularities,
and this will be with co-de-it definition differently.
anyhow something like that should work with co-de-it definition.
i have unfortunately not managed it so far.
maybe you know how to do it?

Attachments:

• Cull.gh, 8 KB