Grasshopper

algorithmic modeling for Rhino

Unable to connect two wires into one 'slot' on a node

I can't get to wires to connect into the same slot of a Loft node to loft curves, or in fact connect two wires into the same slot in general. (I tried plugging both curves into a curve collection then that to the Loft node, but they wouldn't plug into that either).

Tutorials etc take for granted that this is possible. I'd be grateful if anyone could help me out?

Link and image below.

Hexagons.gh

Views: 7663

Replies to This Discussion

Permalink Reply by ng5 Alex on September 3, 2014 at 7:17am

Hello

you can connect multiple wires when you press and hold shift  during connection. you will get a small + sign when trying to connect. (for the second third etc wire)

Permalink Reply by Lorenzo Fernandez on April 1, 2020 at 5:49pm

Thank you so much!

Permalink Reply by SA on September 3, 2014 at 7:17am

Plug one and use shift to plug the next, hope this helps

Attachments:
Permalink Reply by Thomas Lowe on September 3, 2014 at 8:52am

Thanks very much!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service