UCount Value is not valid for this amount of points / API

Replies to This Discussion

Permalink Reply by nikos tzar on July 21, 2015 at 11:57am

Ok, this is what I came up with:

It sets the Z value of each point based on its current acceleration. 

You will need to keep an eye on the panels inside the definition because connection with the site often has problems (or maybe its just my internet connection...) and nulls are inserted and they mess up the definition....

Also (and this was my concern about) you will notice that you can't have horizontal slices with the location of the vessels in a specific point in time anymore, since each one will have a different Z value on the same time stamp.....

Hope this is clear...

Good luck with the project,

Nikos

Attachments:

• surfacepoint6nt.gh, 24 KB

Permalink Reply by Levent Ozruh on July 28, 2015 at 3:47pm

Nikos,

This one is great. Thanks a lot for that.

Lastly, on the topology side, I tried to simplify and exclude kangaroo stuff.

Two short questions on this one;

1) The heights of the peaks (of the mountains or whatever one calls them) are at the same height as the z value is the same for each point, only differing for other points in the grid - based on the behaviour of the graph -. How do I connect that to the acceleration values - included in the document I attached -, so that each have different height but also some having the opposite direction as well?

2) As you will notice on the some parts of the edges of the grid boundary it goes up instead of having a 0 Z value. How do I anchor the whole surface from the naked edge points - the grid points that are at the very outer side 

Thank you,

Best,

L

Attachments:

• Digital Ecologies B Topology.gh, 27 KB

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page