twisted waffle lamp

Replies to This Discussion

Permalink Reply by zeinab gharbavi on August 9, 2017 at 12:38pm

the gh file in attachment 

Attachments:

• twist2gh.gh, 16 KB

Permalink Reply by Hyungsoo Kim on August 9, 2017 at 1:19pm

Hi.

Check "Red Group". Best.

Attachments:

• twist2gh_re.gh, 23 KB

Permalink Reply by zeinab gharbavi on August 12, 2017 at 11:12am

thank you Hyungsoo, that was really helpful. but i also have another problem with my vertical ribs i can't get them correctly, i've tried to flip curves but it's also not working.....

Attachments:

• twist2gh_re.gh, 26 KB

Permalink Reply by Hyungsoo Kim on August 12, 2017 at 12:27pm

Marked in red groups are the parts I modified.

Attachments:

• twist2gh_reV3.gh, 26 KB

Permalink Reply by Hyungsoo Kim on August 12, 2017 at 12:43pm

Note that from a fabrication perspective, it's difficult to make a waffle lamp as it is now.
Keep in mind that vertical and horizontal members should be Interlocked each other by engaging with notchs.
There are a lot of similar cases in ths forum, so please search.

Permalink Reply by zeinab gharbavi on August 18, 2017 at 9:07am

hi hyungsoo, i've noticed the vertical ribs as you modified and i wanted to change the first plane and the last one direction as you see 

but i get a non-uniform curve after i put the 'Nurbs curve'

how can i get the nice curve....

Permalink Reply by zeinab gharbavi on August 18, 2017 at 9:24am

gh. file

Attachments:

• twist2gh_reV3.gh, 34 KB

Permalink Reply by Hyungsoo Kim on August 18, 2017 at 10:00am

It will be better not to think that your extracted planes will return to their original places by merging.

Attachments:

• twist2gh_reV3_re.gh, 35 KB

Permalink Reply by zeinab gharbavi on September 14, 2017 at 10:19am

hi hyungsoo,

excuse me for bothering you,there is another problem with my vertical ribs notches, there's a line across the ribs, and also one of the vertical ribs is not on the right plane ..... it's really confusing 

Attachments:

• twisted rectangle lamp.3dm, 5 MB
• twisted rectangle lamp.gh, 57 KB

Permalink Reply by Hyungsoo Kim on September 15, 2017 at 2:21am

Most of your mistakes happen because you do not care about data matching.

Attachments:

• twistedrectanglelamp2_re.gh, 65 KB

Permalink Reply by zeinab gharbavi on September 23, 2017 at 1:10pm

yes,i know!!.....i am learning grasshopper as a hobby and i really want to learn it but i'm getting confused when it comes to data matching....

thank you for your precious help.