tweaking anchors

Replies to This Discussion

Permalink Reply by Daniel Piker on March 6, 2014 at 11:21am

Hi Kipodi,

AnchorXYZ is a hard constraint - for each dimension it is either on or off (and if on, that constraint will be enforced exactly, no matter what other forces are acting).

If you want to just pull points to a line or surface, you can use Shear, PullToCurve or PullToMesh.

Permalink Reply by kipodi on March 7, 2014 at 3:36pm

hmm.. ok thank you, it would be nice if there was a possibility to have a tweaking component that can take the output force of the xyz anchors and "soften it" .. from a designer point of view.. it's much clearer because usually you fold along axes..

great work by the way, you work is highly appreciated!!