Grasshopper

algorithmic modeling for Rhino

Trouble with Kangaroo's Curve-Pull

Hi! thank you in advance, I'm trying to pull the curve,generated in anemone, to tie it around the cylinder, but I can't succeed to only tie it around and don't let it to go inside the cylinder.
More over, I'd like to know if there's another way in Kangaroo to tie a curve around an object, like a rope that is pulled on one end. Thank youu!

Views: 1691

Attachments:

Replies to This Discussion

Permalink Reply by Petras Vestartas on December 1, 2016 at 11:56am

Can upload file only with geometry for kangaroo without boid library?

Permalink Reply by Manuel on December 2, 2016 at 4:27pm

If you only want to "project" the curve, you can use "Pull Point".

If you still want to use kangaroo, i think you need to anchor one extreme and then use the mouse to grab (alt key) the other extreme and manually pull. Also set the segments lines with original length and points OnMesh.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service