Grasshopper

algorithmic modeling for Rhino

trimmed curves

hi @ll,

if i ve got a curve (degree 3) and trimm it, then evaluate it at (t) via evaluate component in grasshopper, the point at (t) is not at the curve.
how comes this ?

thank u very much

Views: 274

Replies to This Discussion

Permalink Reply by Andrew Heumann on September 5, 2009 at 9:42am
try checking "reparameterize" on the curve parameter - should reset the curve's t domain to 0:1.
Permalink Reply by dcay on September 5, 2009 at 4:42pm
thank u this works well, but is it also possibible in gh - ive built the curves by points in gh...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service