Grasshopper

algorithmic modeling for Rhino

Trim surfaces with surfaces

I want to make holes in certain surfaces (planes) thanks to other surfaces (cones)... and i absolutely don't know how to get it works!

I try to regroup each cones but to keep all the planes separately.. it doesn't work. So i try to swap A and B in the boolean difference, i try to graft the cones and flatten the planes... i don't understand what's wrong.

Thank you in advance for enlighten me!

Views: 33516

Attachments:

Replies to This Discussion

Permalink Reply by Hannes Löschke on November 5, 2012 at 9:04am

SDiff is used for solid boolean differences. Your planes are no solid objects. Your cones don't seem do be solids either. You can make the cones solid by adding a cap.

If that doesn't work, try SolidTrim. This should work with open Breps. Or try to split your planes with the intersection curves and the SurfaceSplit component.

Permalink Reply by Guolt on November 5, 2012 at 9:24am

Hi Hannes!

Yes, i try the surfaceSplit component with the intersection curves i had created.

After many attempts, i get it but i think this is not too 'clean'.. btw it works^^

 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service