Grasshopper

algorithmic modeling for Rhino

Trim/split a sphere in grasshopper

Hi everyone,

simple question...I would like to decide via gh to split my sphere in some position.

It's a silly question I know. I can make it with a mesh but doesn't work with a sphere...Anyone knows why?

thx!

surface%20split.gh

Views: 5024

Replies to This Discussion

Permalink Reply by Aldo Sollazzo on February 17, 2012 at 7:10am

let's see if this one help me...

http://www.youtube.com/watch?v=Mt4mnixNky8

Permalink Reply by Manuel on February 17, 2012 at 12:13pm

i think you need to project a curve on sphere and then use srfsplit with that curve.

also you could use a brep like a box or something and then use solid difference.

Permalink Reply by Aldo Sollazzo on February 17, 2012 at 12:27pm

made it...thx manuel! stupid question thx for the answer! I wasn't tring with solid difference that was the point...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service