Trim Inclusion test does not work

Replies to This Discussion

Permalink Reply by Omar Helmy on January 7, 2013 at 3:12am

Files

Attachments:

• Curve inclusion.3dm, 23 KB
• Curve inclusion.gh, 3 KB

Permalink Reply by djordje on January 7, 2013 at 5:11am

I guess you need to use the "Surface CP (Closest point)" component.

Attachments:

• Curveinclusion.gh, 3 KB

Permalink Reply by Omar Helmy on January 7, 2013 at 6:05am

Thanks djordje,

I was not able to open the script as i'm running an old version of GH here at the office. Can you please post an image of the same.

regards

Permalink Reply by Omar Helmy on January 7, 2013 at 6:07am

I was also wondering, is there a component that tests a point for being on a surface or not directly without using the (Closest point) component?

Permalink Reply by djordje on January 7, 2013 at 6:21am

You will still need to use the Trim Inclusion component, just "Surface CP" goes before it:

Permalink Reply by Omar Helmy on January 7, 2013 at 7:21am

Thanks a million. Worked this time, but honestly i don't fully understand what the untrim surface component does... :)

Permalink Reply by Hannes Löschke on January 7, 2013 at 8:04am

Untrim removes the trimming curve and returns the underlying untrimmed surface. If you calculate the CP to the trimmed surface, all points will at least be placed on the trimming curve. This might move all the CPs into the trim inclusion.

Still CPs aren't ideal to check for trim inclusion, because if your point is pulled to an untrimmed edge, it will be detected as on the trim, even if the original point was far off.

Permalink Reply by Omar Helmy on January 7, 2013 at 8:35am

Hi Hannes,

Yes you are so right. This is what is happening with me. The point is being attracted to an untrimmed side, so is being detected as inside... :(

That's why i'm thinking there must be a better way for doing this (checking whether or not a point is on a specific surface)

Regards

Permalink Reply by Omar Helmy on January 7, 2013 at 9:18am

Hey guys,

I thought i almost figured it out, in a different way. I noticed that the "Surface CP" component also returns a value for the distance between the original point and the CP, so i thought i might use that as a gate for determining whether or not the point is on the surface (distance should be not bigger than zero)

But sadly it still does not work, no idea why... even the points that are supposed to be on the surface, sometime return a very small value :(

Attachments:

• Curve inclusion 02.3dm, 23 KB
• Curve inclusion 02.gh, 4 KB

Permalink Reply by Rajeev Pulari on October 9, 2018 at 2:04am

hi Omar ,

your script is working 

i change panel 0 to 0.01 and multi line option the dispatch out put B gives the  points 

Regards

Rajeev