Trim a curve trough section points ?

Hi all,

I tried to remove a curve part from a curve trough out two paralell lines.

I tried to solve this with Curve/Line Intersection (CLX), then Shatter, but

nothing happens.

Do somebody know what i am doing wrong ? (Picture attached)

Thanks for any replies !

Miklos

Attachments:

Trim curve.jpg, 80 KB

Replies to This Discussion

Permalink Reply by Hannes Löschke on December 4, 2013 at 9:30am

Hard to tell from a Picture, what "nothing happens" means in your case.

Shatter will split the curve at the given t's but all the segments remain. So other than by inspecting the number of segments in S output, you will not see any difference in the viewport. As long as the original curve's preview is still enabled, you will see nothing at all.

Permalink Reply by Miklós Hatvani Deák on December 5, 2013 at 12:24am

Danke Schön !

Permalink Reply by Miklós Hatvani Deák on December 5, 2013 at 7:58am

Would you use shatter to in case of two points ?

I mean cutting a curve with two points. And then trim the curve between the two.

I have attached a pic.

Attachments:

Curve, two points.jpg, 346 KB

Permalink Reply by Hannes Löschke on December 5, 2013 at 2:29pm

Shatter is already half of the way. All you need to do is select the parts of the curve, you want to keep or remove those, you want to discard. Works with points as well as curves.

RSS