Triangulate a polysurface by its curvature

Replies to This Discussion

Permalink Reply by Michael Pryor on July 26, 2017 at 10:40am

There is a surface Curvature component that will give you the curvature value of a surface point.

Permalink Reply by Anders Holden Deleuran on July 27, 2017 at 2:12am

The MeshMachine remeshing component that comes with Kangaroo (below version 2) has a CurvatureAdaptivity input parameter, which allows you to make the mesh edges shorter in regions with tight curvature. You'll need to convert your polysurface to a mesh first and triangulate it (there are standard GH components for this). I'd start out with a fairly dense meshing, which should help retain the original form during remeshing.

Permalink Reply by Tomer Ashkenazi on July 30, 2017 at 6:26am

Hello Andres, thank you for your reply.

I followed the steps you have suggested, triangulated the mesh but couldn't connect to the "remesh" tool to get a response.

I've attached a jpg file that shows the result so far. is that the tool you mentioned?

tnx,

Tomer.

Attachments:

• forum_2.jpg, 365 KB