Triangle

Hello,

I am Jon,

Could anybody help me, I want to draw a triangle, but the triangle sides must be the same length all the time even changing the points position.

Is there any definition to do that?

Thanks

_triangle.gh

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Danny Boyes on May 14, 2013 at 3:34am

What is the criteria for the placement of the third point?

Permalink Reply by JonRico on May 14, 2013 at 4:17am

Imagine a sino curve, where the circles are going to have the centre point, from there we intersect several times in different points between different circles. What I don't know how to reach it what is sketched and again keeping the sides the same length

hope u understand

Permalink Reply by Danny Boyes on May 14, 2013 at 4:58am

something like this

Attachments:

triangleProblem_mk2.gh, 12 KB

Permalink Reply by JonRico on May 21, 2013 at 4:03am

Hei Danny,

is there any possibility to make the definition shorter than what I have?

thanks

Attachments:

deficion simple21mayo.gh, 77 KB

Permalink Reply by Danny Boyes on May 21, 2013 at 4:12am

With a quick glance I would say yes there is room for simplification. However I don't have time right at this moment to go into in such depths, but I would like to help, what deadlines are you working towards?

Permalink Reply by JonRico on May 21, 2013 at 4:16am

Next week,

I would appreciate it

thanks a lot

I will wait for ur help.

Permalink Reply by Danny Boyes on May 24, 2013 at 5:06am

Hi JonRico,

What version of Grasshopper are you able to use. If I work on this in 0.9.0050+ will you be able to access it?

Or do I need to roll back to 0.9.0014?

Permalink Reply by JonRico on May 24, 2013 at 8:04am

In which version did u start to work?
I think I have the earlier version but can download the recent one

Permalink Reply by Danny Boyes on May 24, 2013 at 8:05am

You can use Rhino 5? yes?

Permalink Reply by JonRico on May 24, 2013 at 8:06am

No Rhino4

Permalink Reply by Danny Boyes on May 24, 2013 at 8:12am

I will have to roll back to 0.9.0014 then.

I have a couple of questions I'll PM you with.

Permalink Reply by Danny Boyes on May 24, 2013 at 9:10am

I don't know Why you have done certain things like create more circles than you need and then select only a few and some twice but I have had a first stab at what I believe to be the intended results.

Have a look and see if this is true.

Attachments: