Grasshopper

algorithmic modeling for Rhino

Translate vector into lines/curves

Hi I was wondering if there was a way to convert vectors into lines. I have a definition that mimics the nature of the L-System, but I'm having trouble translating the vectors into lines. Hope it's not too much to ask. Thank you.

9-15%20GH%20DGRM%20exponential%20growth.gh

Views: 12329

Replies to This Discussion

Permalink Reply by David Rutten on September 23, 2011 at 4:16am

Hi Nicholas,

 

there's a Line SDL component (SDL = Start Direction Length) which allows you to create a line segment from a start point and a vector.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service