Transferring Pachyderm framework to new model

Hi,

I am testing out my pachyderm framework on a new model, and I am encountering a couple issues.

1) I am getting this error: 1. Solution exception:Number of Grasshopper Objects(GG) and number of Rhino Layer(GL) indices must match (one layer per object). I have 2 Breps from Grasshopper Geometry, so I thought a panel with "2" in it would work, but it didn't. So I tried a multiline data panel with "1" enter "1" and that didn't work either. Thoughts on this?

2) I can assign the source to a point in Rhino, but Rhino and Grasshopper crash when I try to assign the receiver to a point. This also happens when I assign the receiver successfully first and then try to assign the source. Thoughts on this too?

Thanks!

Attachments:

rotating panels.3dm, 43 KB
rotating panels.gh, 69 KB

Replies to This Discussion

Permalink Reply by Sam on February 19, 2019 at 10:29am

In addition, how would I specify the Rhino layer for each Brep in Grasshopper separately? So Brep 1 would be one material and Brep 2 would be another material. Is it a multiline data panel (that didn't work for me)?

Permalink Reply by Arthur van der Harten on February 20, 2019 at 5:54am

I don't typically use multi-line data panels, but I have seen people do it. My approach is typically to right click on the input, and use the "Set Multiple..." command.

Arthur

Permalink Reply by Sam on February 20, 2019 at 7:59am

In this version of the Grasshopper sketch i have the box as one brep and the accordion panels as another. So I expected the number of integers to put for Grasshopper Layers to be two (e.g., 0,1) so that I can specify different materials for the box and panels. Even using Set Multiple or a multiline panel, it gives the same error about a mismatch in the number of layers. The only way I avoid the error is to use a number slider to feed Grasshopper Layers one integer.

rotating%20panels.gh

Permalink Reply by Arthur van der Harten on February 20, 2019 at 5:52am

Hi Sam,

I can't seem to reproduce these errors when I start a new model, but in your models, for some reason this is an issue. I will have to try some things, and get back to you.

Arthur

RSS