Grasshopper

algorithmic modeling for Rhino

Topmod starball, how to do this with grasshopper?

Hello GH community.

After lots of tuts and play around with GH, I love it.

Today, I stumbled on one single image which I immediately fall in love with the model, http://th02.deviantart.net/fs19/PRE/f/2007/285/d/1/TopMod_StarBall_..., I tried to do this with GH+Rhino, failed. My knowledge of GH is still very limited.

I am wondering could the GH community give a hit? P.S I have managed to produce the starfish like shape, but the part which stopped me is the interlinked and how to put this starfish shape onto a sphere and connect each of the tentacles?

Views: 1845

Replies to This Discussion

Permalink Reply by Shridhar Mamidalaa on May 11, 2015 at 1:09pm

Permalink Reply by Bizkit on May 11, 2015 at 11:05pm

Wowowowowwowowow, Shridhar You did it!! closer. Tricky part is how do we interconnect the tentacles.

Permalink Reply by Bizkit on May 11, 2015 at 11:11pm

Even with Topmod, to connect the 'tentacles' is so tricky. Very careful with the selection.

Permalink Reply by Kim hauer on May 12, 2015 at 12:50pm

Good luck with that!

Permalink Reply by Bizkit on May 12, 2015 at 5:14am

Hi Alex

Thank you for the info. Many times, I just through Topmod crashed. I should have given it more time.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service