Grasshopper

algorithmic modeling for Rhino

Timber Tower Diagonal Beams

1. I have attempted to put diagonal beams, however, I think the way i did it is wrong, as you can see the diagonal beams is broken into multiple members, but I just want it to be one single member (please refer to my gh)

2. At the moment the diagonal beam is running into the horizontal beam, is there a way to make it sit behind the horizontal beam, like the attached image I have drawn

Views: 510

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 18, 2016 at 12:55pm

Check attached.

Attachments:
Permalink Reply by Charisa on September 18, 2016 at 10:52pm

Thank you for that, how can I make it flush with the top, because at the moment it is not touching the top horizotal beam

Attachments:
Permalink Reply by Hyungsoo Kim on September 19, 2016 at 1:05am

Next time, you should run your own errand of minor detail.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service