This is my error of GH 57 with Rhino 5.0

Replies to This Discussion

Permalink Reply by David Rutten on October 4, 2010 at 4:44pm

Hi Andres,

when you run the Grasshopper command again, does it work the second time?

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by Andres Gonzalez on October 4, 2010 at 6:06pm

I will try tomorrow, I am at home now...

Permalink Reply by Andres Gonzalez on October 5, 2010 at 8:20am

Sorry, it does not work the sencond time....

Andres

Permalink Reply by Andres Gonzalez on October 5, 2010 at 8:24am

I found the problem... It is not GH it is RhinoCAM. I to Options, Plug-ins, Enable Load Protection and did not load the RhinoCam Plug in, then, type GH as usual and it runs....

Andres

Permalink Reply by David Rutten on October 5, 2010 at 8:31am

Thanks for following up Andres. I have a vague memory this came up before. There's no good reason why RhinoCam could screw over a piece of pure Grasshopper code. At least no good reason I know of. I'll bring it up at the mcneel developer meeting today, perhaps someone else has an idea what's going on here.

--
David Rutten
david@mcneel.com
Poprad, Slovakia