Grasshopper

algorithmic modeling for Rhino

Textured/Wave Facade

Looking to do something along these lines(Perot. SFMOMA). I have attached the script and rhino file, any help would be greatly appreciated.

There is an issue with the second panel as you can see in the image, Ive tried doing different things but no luck

Views: 4029

Attachments:

Replies to This Discussion

Permalink Reply by mire on March 11, 2017 at 4:52am

Hi Jose, Your third curve has a different direction than the first 2. You can change this by using "Flip" command in Rhino on that curve, or "Flip Curve" component in Grasshopper on the same curve

Permalink Reply by Jose Espino on March 14, 2017 at 12:44pm

thanks! Hate when you miss something so small.

Permalink Reply by Hyungsoo Kim on March 11, 2017 at 9:33am

Hi.

Check this a little bit clumsy definition if you want.

It needs "Weaverbird" plug-in.

Attachments:
Permalink Reply by Jose Espino on March 14, 2017 at 2:32pm

thank you very much! Script is a bit complex for me, but it works and its pinpoint accurate on what I was looking, thanks again.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service