Grasshopper

algorithmic modeling for Rhino

Tessellation and culling duplicated surfaces

So I have been working on this tower design and I am using a Tessellation script written by Jon Mirtschin I believe. I would like to be able to only select the surfaces that are facing the outside air ( In other words, I wanna cull every surface that has a another surfaces touching it. So I am only able to manipulate the outer skin )

The Geometries am getting are all Breps. Each as a cell you can say.
Any ideas how I can do that ?

Moe

Views: 562

Replies to This Discussion

Permalink Reply by Mohanned Iskanderani on October 27, 2014 at 2:12am

I found a script that gives me the reversed result for what I want. I wana cull these surfaces from the original once and just have the outer once.

Permalink Reply by Rutger D on October 27, 2014 at 4:18am

You can try this:

Permalink Reply by Mohanned Iskanderani on October 27, 2014 at 5:38am

This is pretty amazing. Exactly what I needed to do

Thank you

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service