Tensile Structure Anchor Points

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 22, 2017 at 8:35am

Hi.

Check attachment and you'll need Kangaroo 2.

Attachments:

• anchorpoints_re.gh, 24 KB

Permalink Reply by Hyungsoo Kim on October 22, 2017 at 8:55am

Better one..

Attachments:

• anchorpoints_reV2.gh, 15 KB

Permalink Reply by Daniel Piker on October 22, 2017 at 9:08am

ah, didn't see your second reply when I was making mine!

Thanks :)

Permalink Reply by Daniel Piker on October 22, 2017 at 9:00am

Also - the Anchor points now have a second input for the target point, so you can also do it like this:

Permalink Reply by Daniel Piker on October 22, 2017 at 9:11am

I often set it up like this and internalise the points for the targets, then edit them with the gumball.

This way you can reset the solver, and still keep the same targets.

If you do want to go back to the original positions you can just connect the points and internalise again.

Permalink Reply by Hyungsoo Kim on October 22, 2017 at 2:00pm

Thanks for showing a useful trick, Daniel.

Permalink Reply by aLEX hERNANDEZ on August 27, 2019 at 10:20am

Hi guys.

Sorry, but how could I add more than 4 footings?