Grasshopper

algorithmic modeling for Rhino

Tensile srf using the kangaroo 2_001

This link

→http://www.grasshopper3d.com/forum/topics/tensile-srf-using-the-kan...

I'm trying to tensile structures.

Though only the same turn threw a turn up, it did not become flat

Do you understand it for some reason?

New user to grasshopper but very impressed with the software so far! Any help is greatly appreciated!

Thanks.

Momiji

Views: 853

Attachments:

Replies to This Discussion

Permalink Reply by Martin Siegrist on October 13, 2016 at 1:04am

I haven't opened your definition yet but I'm guessing you want some anchors on a tilted plane and others should be horizontal. Try to create two independent groups of anchors.

Permalink Reply by Y.Kate on October 13, 2016 at 2:01am

Thank you for a reply!

However, the program did not start well

Permalink Reply by Hyungsoo Kim on October 13, 2016 at 7:41am

Hi.

Have a look at the attached definition.

I've modified your previous definition a little bit and also scaled your base mesh to 1/1000(mm-->m)in order to get on without malfunctioning.

Attachments:
Permalink Reply by Y.Kate on October 13, 2016 at 7:55am

Thank you for plain explanation!

It is the program that I wanted to know.

Thanks again!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service