Grasshopper

algorithmic modeling for Rhino

tensile membrane

Hi people,

I would like to use kangaroo to achieve something like the model shown the attached image. However I'm not quite sure where to start in order to get a tensile membrane behave physically correct in order to make the rods be in compression. Can anyone point me in some direction??

Thanks in advance!

Views: 1495

Replies to This Discussion

Permalink Reply by RENE on February 27, 2013 at 3:32am

I also meant to show this other image more clearly; the intention is to be able to pull 'points' in the membrane. thanks again!

Permalink Reply by Daniel Piker on February 27, 2013 at 3:50am

Hi Rene,

See the attached definition to get you started.

Hope that helps

Attachments:
Permalink Reply by RENE on February 27, 2013 at 4:01am

thanks Daniel, this is a great starting point, I'll post progress soon!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service